Brava Composite Roof Systems Ordering Template

Brava has minimum standards for ice and water shield installation under Brava roof systems (outlined below).

Tarco LeakBarrier PS200HT High Temp Ice and Water Shield

$ 117.95 USD

Per Roll

Covers 2 Squares (200 square feet)

To see full description of this Brava product, click here

Tarco LeakBarrier MS300 Self-Adhered Ice and Water Shield

$ 59.90 USD

Per Roll

Covers 2 squares (200 square feet)

To see full description of this Brava product, click here

No items found.

No items found.

No items found.

Upload Your Eagleview (3D Aerial Report) and We'll Send Your The Materials List with Detailed Pricing

Thank you! Your submission has been received!

Oops! Something went wrong while submitting the form.

Tarco MS 300 ice and water shield products are 3rd party tested and have been approved by the most strictest of jurisdictions.

Use ice and water shield to protect the areas penetrations

Sealing areas around Bullet Boots for added security against leaks

Ice and water shield around attic vent openings

Ice and Water Shield around pipe boots

Below are the Brava minimum standards for the ice and water shield roof component. The Tarco MS 300 ice and water shield product far exceeds these standards.

Ice and Water Shield

Single layer of 36 mil rubberized asphalt on 4 mil polyethylene carrier sheet
A 36" wide sheet in all valleys is recommended
1 row of 36" wide along all eaves, lap end joints 6" and side joints 3" extended 3' inside the plate line
Apply around all dormers, roof projections, skylights, etc.
Always refer to your local building codes

NOTE: Ice and water shield should not be installed over the felt.

‍

‍

Contact
Form

Send us a message

We're here to help you!

Hi! Contact us and we'll reply A.S.A.P. Thank you.

Thank you! We have received your message. We are looking into this as we speak and will get back to you as soon as possible.

Oops! Something went wrong while submitting the form.