Florida Building Code Approved #FL3066-R2. 11 1/8″ x 15″ Base Measurements. Economic roof pipe boot flashing for use instead of lead pipe boot. Fits pipes between 1 1/4 inch to 3 inch pipes. Free Shipping
20 units per box.
Thermoplastic hard base with elastomer collar.
Fits any roof pitch to 45° (1 ½" and 2" vent pipeallow for a pitch range beyond 45°)
Tested for ultraviolet, ozone and weather resistance
Approved for type “B” installations
Elastomer collar heat tested to 180°F
Multi-size flashing fits 1 ¼" – 3"
Limited Lifetime Warranty for the life of the current roof system
20 units per case
26 cases per minimum Bulk Order
520 units per minimum Bulk Order
Furnish and install hard plastic base roof vent flashing with adjustable, multi-size elastomer collar. Unit shall be Water Tite item number checked below as manufactured by IPS Corporation, as per corresponding dimensional characteristics, or equivalent.
(Do not use Petroleum based mastics, sealing compounds, or paints on collar portion of all flashings, on all hard base, flexible , or rain collars.)
1. Select appropriate size flashing for each vent pipethrough roof. Seal the underside of the flashing asshown below.
2. Install flexible collar* over pipe.
3. Push down until base lies flush on rooftop.
4. Nail flashing only where future courses of shingles willcover.
5. Shingle around the bubble of the flashing (cuttingwhere necessary so all shingles are flat on the roof).The shingles should be installed at least halfway downthe flashing base so there are no exposed nail heads.