Razorback RidgeVent is a long life universal ridge vent roll for ventilation of metal roofing panel systems. Quick and easy installation with hot melt adhesive strips. Convoluted foam with UV inhibitor coating designed to fit most metal roofing panel profiles. Used to close the gap between ridge or hip cap and metal roofing panels. Florida Building Code Approved
Features:
• Inexpensive, quick and easy to install
• Designed for many roof panel configurations and pitches from 2/12 to 20/12
• Low profile attractive installed appearance
• Does not scratch painted metal surfaces
• This product has a Florida Building Code Product Approval number
Specifications
Test Standard Result
100 MPH Wind D R TAS100 Passes
CRL 6875 Passed
Net Free Area 3/4” Rib Panel 17 Sq inch per , ridge linear feet
Air Permeability ASTM D737 840 cu ft / min
Attic Dust ASTM D1739-98 No Clogging
Abrasion ASTM D1175 No Damage
Sizing Suggestions
A minimum of 25% compression suggested
1-1/2” Tall for 5V Crimp, 3/4” high rib, 1” snaplock and corrugated panels with a major rib height of 1” or less.
1-3/4” Tall for R/PBR Panel or metal roofing corrugated panels with major rib of 1.4” or less.
Safety Based on current data, this product is not hazardous in the meaning of the Hazardous Material Regulations. Do not eat. We recommend that you take care, in use and disposal of this product. Make sure to dispose of adhesive release paper immediately after peeling, do not leave on roof surface.
Peel back adhesive release paper beyond the length of product you need. Adhere adhesive side to metal flashing/ clean surface. Immediately dispose of release paper in a safe fashion. Do not leave release paper on roofing surface. Install the metal flashing per panel manufacturers recommendations. When allowable per panel manufacturers specifications install fasteners through the flashing and through the center of the Razorback product into the substrate.